HOW TO MAKE A MINIATURE BOAT REMOTE
Here I will share my experiences in making miniature boats that can be run by remote control, making these vessels can say simple because it is not too complicated, and the goods could be looking at a nearby store.
I will briefly give examples of images that I have made the ship based on my efforts below:
from the picture above I will give step shipbuilding from the image into three short
A. make a sketch on the basis of the shipyard in a later paper printed on a plywood using carbon paper and cut out the appropriate form of drawing sketches there are four sections and each "two parts have the same shape and the bottom side
2. make the station "bulkhead "in the ship
3. patched corners "are still hollow vessel with silicone to prevent leaking and then buy a car is a remote control can also be used
then take the engine and then move into the vessel in such a way
4. and then give (propellers), rudders and other additional support that can make your own with zinc
5. It's up to the design, can also mimic my designs like this
6. after that make up all the basic form and then you plamir on each section to obtain the form of a neat and smooth when dry rub rub the area with paper fibers that are not visible from the plywood
7. appropriate paint color that you are creative and like to get the maximum results
8. after the test vessel in the water so it deh.
ask if anyone on ... please post the coment!
Here I will share my experiences in making miniature boats that can be run by remote control, making these vessels can say simple because it is not too complicated, and the goods could be looking at a nearby store.
I will briefly give examples of images that I have made the ship based on my efforts below:
from the picture above I will give step shipbuilding from the image into three short
A. make a sketch on the basis of the shipyard in a later paper printed on a plywood using carbon paper and cut out the appropriate form of drawing sketches there are four sections and each "two parts have the same shape and the bottom side
2. make the station "bulkhead "in the ship
then take the engine and then move into the vessel in such a way
6. after that make up all the basic form and then you plamir on each section to obtain the form of a neat and smooth when dry rub rub the area with paper fibers that are not visible from the plywood
7. appropriate paint color that you are creative and like to get the maximum results
click here to see the sample of that boat
0 komentar:
Posting Komentar